Tag: 17413-10-4

With the rapid development and complex challenges of chemical substances, new drug synthesis pathways are usually the most effective.17413-10-4,(2,3-Dihydrobenzo[b][1,4]dioxin-6-yl)methanamine,as a common compound, the synthetic route is as follows.,17413-10-4

To a solution of ethyl 8-(benzyloxy)-5-hydroxy-4-methyl-7-oxo-7,8-dihydropyrido[2,3-d]pyrimidine-6-carboxylate (145 mg) and triethylamine (113 muL) in methylene chloride (5 mL), trifluoromethanesulfonic anhydride (130 muL) was added dropwise under ice cooling, and the mixture was stirred at room temperature for 1 hour. The solvent in the reaction mixture was distilled off under reduced pressure. To the obtained residue, ((2,3-dihydro-1,4-benzodioxin-6-yl)methyl)amine (102 mg), triethylamine (170 muL) and dioxane (10 mL) were added, and the mixture was stirred at room temperature for 3 hours. The solvent in the reaction mixture was distilled off under reduced pressure. The obtained residue was purified by silica gel column chromatography [eluent: 60-0% hexane/ethyl acetate] to obtain a brown oil (208 mg). To the obtained brown oil (208 mg), methanol (10 mL) and a 1 mol/L aqueous sodium hydroxide solution (10 mL) were added, and the mixture was heated with stirring at 60 to 70C for 2 hours and 30 minutes. After cooling of the reaction mixture, the solvent was distilled off under reduced pressure, and ethyl acetate and water were added to the residue. An organic layer was separated, washed with a saturated aqueous solution of sodium chloride and then dried over sodium sulfate, and the solvent was distilled off under reduced pressure. The obtained residue was suspended in a mixed solvent of methanol, 2-propanol and diisopropyl ether, and the deposit was collected by filtration to obtain a pale yellow solid of 8-(benzyloxy)-5-(((2,3-dihydro-1,4-benzodioxin-6-yl)methyl)amino)-4-methylpyrido[2,3-d]pyrimidin-7(8H)-one (57 mg). 1H-NMR (CDCl3) delta value: 2.93 (s, 3H), 4.25 (d, J=4.6 Hz, 2H), 4.28 (s, 4H), 5.23-5.33 (m, 3H), 5.73 (s, 1H), 6.81-6.94 (m, 3H), 7.35-7.44 (m, 3H), 7.65-7.74 (m, 2H), 8.89 (s, 1H).

17413-10-4 (2,3-Dihydrobenzo[b][1,4]dioxin-6-yl)methanamine 87102, abenzodioxans compound, is more and more widely used in various.

Reference£º
Patent; Toyama Chemical Co., Ltd.; KAWAI, Hyouei; MURATA, Daigo; SUZUMURA, Yuko; EP2810944; (2014); A1;,
Benzodioxan
1,4-Benzodioxane | C8H8O2 – PubChem

(2,3-Dihydrobenzo[b][1,4]dioxin-6-yl)methanamine, cas is 17413-10-4, it is a common heterocyclic compound, the benzodioxans compound, its synthesis route is as follows.

To a solution of fers-butyl (25)-2-{[(6-methoxy-l,5-naphthyridin-4-yl)amino]carbonyl}- 5-oxopiperidine-l -carboxylate (1.19 g) in dichloroethane (50 mL) were added l-(2,3-dihydro- l,4-benzodioxin-6-yl)methanamine (0.60 g) and sodium cyanoborohydride (NaCNBH3) (0.42 g). After stirring at room temperature 60 hours, the reaction was concentrated. This residue was purified by flash chromatography using a FlashMaster using ethylacetate and hexane as eluants yielding 0.45 g of the title compound. ES (M+H)+=550.

With the rapid development of chemical substances, we look forward to future research findings about 17413-10-4

Reference£º
Patent; ASTRAZENECA AB; ASTRAZENECA UK LIMITED; WO2006/125974; (2006); A1;,
Benzodioxan
1,4-Benzodioxane | C8H8O2 – PubChem

(2,3-Dihydrobenzo[b][1,4]dioxin-6-yl)methanamine, cas is 17413-10-4, it is a common heterocyclic compound, the benzodioxans compound, its synthesis route is as follows.

General procedure: A 15mL capped tube was charged with intermediate 11 (64 mg,0.2 mmol) and corresponding amine (1.0 mmol). The degassed isopropanol (5 mL) was added. The tube was flushed with argon,capped, and heated at 140 C for 12-48 h. After cooling to roomtemperature, the reaction mixture was concentrated in vacuum,and the residue was purified by column chromatography (EtOAc:PE = 1:2) to give the target compounds 6a-r.

With the rapid development of chemical substances, we look forward to future research findings about 17413-10-4

Reference£º
Article; Li, Peng; Wang, Bin; Zhang, Xinwei; Batt, Sarah M.; Besra, Gurdyal S.; Zhang, Tingting; Ma, Chen; Zhang, Dongfeng; Lin, Ziyun; Li, Gang; Huang, Haihong; Lu, Yu; European Journal of Medicinal Chemistry; vol. 160; (2018); p. 157 – 170;,
Benzodioxan
1,4-Benzodioxane | C8H8O2 – PubChem

17413-10-4, (2,3-Dihydrobenzo[b][1,4]dioxin-6-yl)methanamine is a benzodioxans compound, ?involved in a variety of chemical synthesis. Rlated chemical reaction is continuously updated

To a 500 mL three-necked flask was added 42 g of compound 7b, 400 g of N-methylmorpholine and 250 mL of DCM, stirred for 10 min,Ice bath cooling to l C; start slowly dropping 38g pivaloyl chloride, control the internal temperature is not higher than 20 C, after the drop, the roomTemperature stirring reaction, TLC in the control, after the end of the reaction, with 100mL 0.5N dilute hydrochloric acid to adjust the pH value to 6 ~ 7, liquid, organic phase100mL washed twice, 15g yuan powder drying, pumping, concentrated under reduced pressure, petroleum ether beating, suction filtration, vacuum drying to get 55g compound6b, purity: 99.1%, yield 86%

17413-10-4 (2,3-Dihydrobenzo[b][1,4]dioxin-6-yl)methanamine 87102, abenzodioxans compound, is more and more widely used in various.

Reference£º
Patent; Astatech (Chengdu) Pharm. Co., Ltd.; Chen, Xing; Wang, Gang; Luo, Jianye; Tang, Jian; Chen, Jiachang; Chen, Tao; Yang, Youzhe; (15 pag.)CN106366089; (2017); A;,
Benzodioxan
1,4-Benzodioxane | C8H8O2 – PubChem

With the rapid development and complex challenges of chemical substances, new drug synthesis pathways are usually the most effective.17413-10-4,(2,3-Dihydrobenzo[b][1,4]dioxin-6-yl)methanamine,as a common compound, the synthetic route is as follows.

Example-8Preparation of 2,3-dihydro-benzo[1,4]dioxin-6-yl-methylamine hydrochloride 242.0 g of Methanolic ammonia [as 100% w/w by chemical assay] [Note: as chemical assay: 23.0% w/w, volume 1350.0 ml] and 30.0 g (0.183 mol) of 1,4-benzodioxan-6-carboxaldehyde were charged into a 2.0 L 4 necked round bottom flask, connect to a mechanical stirrer, thermo meter socket and condenser at 20-30 C. Stirred the mass for 20-30 min at 20-30 C. After dissolution is clear. Reaction mass was charged into a 2.0 L hydrogenator kettle at 20-30 C. 30.0 g of Raney Nickel (with Methanol dried) was charged under nitrogen atmosphere. Kettle was fitted to the hydrogenator. Nitrogen atmosphere was removed in Hydrogenator kettle with hydrogen gas by slowly flushing. Hydrogen gas was feeded upto 50-55 psi in hydrogenation kettle under oscillation. Maintained the hydrogen gas pressure (50-55 psi) till the hydrogen gas consumption is stopped. Reaction mass temperature was raised to 40-45 C. After hydrogen gas consumption is stooped at 45-50 C. Reaction mass temperature was cooled to 25-30 C. Maintained the hydrogen gas pressure at 50-55 psi for till the hydrogen gas consumption is stopped (about 90-120 min) Raney nickel was filtered through hyflow bed under nitrogen atmosphere. Raney Nickel was washed with 300.0 ml of methanol under nitrogen atmosphere. Filterate was collected into a flask. Methanol was distilled completely under vacuum at mass temperature not crossing 55 C. Mass temperature was cooled to 40-45 C. and release the vacuum. 50.0 ml of isopropyl alcohol was added. Reaction mass pH was adjusted to 0.5+/-0.25 with IPA HCl. Maintained the mass temperature at 25-30 C. for 60-90 min under stirring. Solid was filtered and solid was washed with 20.0 ml of isopropyl alcohol. Compound was dried under vacuum at 40+/-5 C. Dry compound weight: 31.0 g (yield: 84.1%).Spectral data:FT-IR (K Br) (cm-1): 3447.6, 2977.6, 2870.0, 1594.5, 1506.6, 1474.0, 1285.8, 1077.7, 1051. 735.2, 617.9, 472.0MS: 202.6 [M+1]

As the paragraph descriping shows that 17413-10-4 is playing an increasingly important role.

Reference£º
Patent; Natco Pharma Limited; US2010/298351; (2010); A1;,
Benzodioxan
1,4-Benzodioxane | C8H8O2 – PubChem